RM80698046 Aftermarket Scraper Limit Switch Micro Switch for 6820 7820 7620 Pavers

When the scraper on your paver starts stopping in the wrong position, or the signal drops out during paving, the limit switch is usually the first part to check. This RM80698046 micro switch is the aftermarket replacement for that position — same mounting, same terminal layout, no rewiring.

• Part number RM80698046 — ready to fit Built to the reference so the switch sits in the original bracket and the two mounting holes line up without drilling or shimming.
• One reference for 6820 / 7820 / 7620 Three of the most widely used paver models share this switch, so a single line in your stock list covers all of them.
• Clean switching, less scraper hunting Snap-action contacts give a stable on/off signal to the scraper control circuit, so material feed stays even and the screed does not run short of mix.
• Pocket-size spare, minutes to change Only 0.2 kg per piece. Keep one on the service truck and swap it during a paving break instead of losing a shift.
• Checked before it leaves the warehouse Every unit is contact-tested, then packed in anti-shock carton, wooden case or pallet depending on order volume.

The switch is used on the scraper height sensing position. Before ordering, compare the reference number stamped on the old switch with RM80698046 — if the number differs, send us a photo of the part and the machine plate and we will cross-check it for you.